
Phil shows you how to use a simplex jack. We jacked up a porch with this tool. ⏱️⏱️Chapters⏱️⏱️00:00 Follow along with a handyman00:25 How to work simplex jack01:34 Be an American, not an American’t 🙏 Subscribe, 👍, it helps a lot!!➤❓/ 💬: ask@straight...

How to cut Dormers Metal Roof ⏱️⏱️Chapters⏱️⏱️00:00 Intro00:22 How to cut dormers00:40 You will have varying angles00:50 First on the valley you want to fasten way back from where metal might come under01:05 Go 4″, you could go 6″ you want to be back...

Dig it out til it’s level, where you won’t be sitting tilted. “Okay.” Not that we have that much weight, it’s just good habit. And that 2 by 10, or whatever it is, right there beside you can be knocked out. I don’t think that’s doing anything. Should...

We’ll put these lag bolts with the washer on and it’s going to be driven by deep impact on electric impact. Now they’re making battery powered impacts pretty strong. They were they can take a semi-trailers off, but I don’t have anything that expensiv...

The screws will hold some, but some 250 lb people walking on that stepping. The thing about people, they’re overweight. They say when they start going down steps, they step really hard. I have a place that has like 15 steps down and the bottom steps...

Phil shows you how to install angled sheet metal. ⏱️⏱️Chapters⏱️⏱️00:00 Follow along with a handyman00:25 Installing angled piece of metal01:00 Home Depot was out of straight snips when they went01:30 What if it’s a long valley?02:10 Why he’s screwin...

Phil shows you some quick tips and tricks on cutting thick sheet metal. ⏱️⏱️Chapters⏱️⏱️00:00 Follow along with a handyman00:25 Cutting the metal for the valley01:55 Wiss Snips to cut 26 gauge material03:31 Why I use straight snips05:00 Be an America...

All right now, we’ve got a metal coming from there to here. You can’t always count on the framing on the sofit and fascia or the roofing to be square. So you want to try to catch it as you go along. Hey, I’m running out of square. You want to squeeze...

How to measure and adjust metal roofing for the angles ⏱️⏱️Chapters⏱️⏱️00:00 Follow along with a handyman00:25 Mark your valley00:35 You need to know what your bottom of the valley is00:56 Take tape measure where your angle will start01:40 Usually ha...

All right. So what we’ve done is run screws through the rib right here into the one by four about every two feet or more or less. More is not going to be worse. And then we’re going to seal this up here so water doesn’t stay in there and leak behind,...